How Can I Customize My Trunk Liner or Cargo Liner?

More than likely, we have the standard dimensions on file to make trunk liner products fit your car perfectly. If, however, the standard dimensions don't quite fit your specific needs, we're happy to customize them at no extra charge.

Shown below are the customisation options you can choose and the measurements you'll need to take for your car. If you will need any of the customisation options below, you will want to have these measurements ready before you place your order.

Customization Options

Trunk Length

You can customise the length of your trunk liner or cargo liner to fit your needs. If, for example, your side length differs to your center length, we can curve the rear edge of the trunk liner to fit.

Here are the measurements we'll need:

• Side Length

  Measure the left and right sides of your trunk from the base of your seats along the sides to where it touches the rearmost part of the trunk.

• Center Length

  Measure the center length of your trunk from the base of your seats straight back to the rearmost edge of your trunk where the tailgate closes.

Trunk Width

You can customise the width of your trunk liner or cargo liner to fit your needs.

Here are the measurements we'll need:

• Primary Width

  If your trunk has wheel arches, measure the minimum width between the wheel arches.

• Maximum Width

  Measure the full width between the sides of your trunk as shown in the diagram.

Wheel Arches

US Trunk Liners are typically designed to fit between the wheel arches of your trunk. If your vehicle has wheel arches, this can give you the added benefit of extra storage on either side of the trunk liner. For some cars we may be able to do a slightly more fitted Trunk Liner, i.e The Trunk Liner will fit between the wheel arches and then flare out towards the tailgate.

In addition to the width measurements above, here are the measurements we'll need:

• Wheel Arch Length

  Measure from the base of your seats to the point your arches begin to curve.

Boot Height

You can customise the height of the back and sides of your trunk liner or cargo liner to fit your needs.

Here are the measurements we'll need:

• Back Height

  Measure the height of your back seat from the bottom, along the angle of your seats (if applicable) to the point you want your trunk liner to stop. We make your trunk liner back panel to match the angle of your rear seats.

• Side Height

  Measure the height of the side of your trunk to the point you want the sides of your trunk liner to stop.

Trunk Liners and Cargo Liners for Dog Owners

We can customize your liner with a series of small punched holes along the high back seat panel, so with the supplied lacing you can easily secure it to your dog guard or rear seat headrests.

Bumper Protector

Our Bumper Protector is made to fit the width of the opening of your boot. You can customise the Bumper Protector if you need a more narrow width.

Here are the measurements we'll need:

• Bumper Protector Width

  Measure across your trunk opening for your preferred width. Also measure the length required allowing about 4 inches on the trunk base, and dropping down outside your car to the level required.